
WM710
WM710 Manual Wheel Blasting Machine
Manual wheel-surface preparation with front loading, a rotating table and built-in filtration. Choose the blasting medium to suit the next coating stage.
M&H Group / Thailand & APAC
- Table diameter
- 698.5 mm (27.5 in)
- Compressed air
- 250-1,000 L/min
- Exhaust fan
- 900 m3/h max
- Supply
- 110 / 230 V, single-phase, 50/60 Hz
Wheel Restore
Speak with M&H Sales


A controlled wheel-repair workflow.
Load from the front
Select media for the finish
Prepare for the next coating
Surface preparation
Product details.
- Article number
- WM710
- Dimensions (H x W x L)
- 1,850 x 1,000 x 1,000 mm
- Table diameter
- 698.5 mm (27.5 in)
- Compressed air
- 250-1,000 L/min
- Exhaust fan
- 900 m3/h max
- Supply
- 110 / 230 V, single-phase, 50/60 Hz
- Filtration
- Integrated filtration
Machine dimensions do not include working clearance. Wheel sizes show metric equivalents alongside customary inch designations.
What should I check before ordering?
Share your wheel sizes, expected volume, available floor space and utilities. We will confirm the supplied equipment, installation, training and aftersales arrangements in your quotation.
Ask M&H Sales →Use & care
M&H will confirm the supplied configuration and compatibility in your quotation.
Documents & product advice
Selection and use
- Manual or semi-automatic
- WM710 is manually operated. WM750 adds an electric front loader, adjustable blasting position, quick settings, media-change reminders and diagnostics.
- Media and maintenance
- Fine, medium and coarse media are listed with the machines. The media-change opening provides access for replacement. Select media for stripping, repainting or clearcoating rather than substituting ordinary sand.
- Filtration
- The manufacturer describes cyclone separation for reusable media, a polyester filter cartridge and pressure monitoring for filter clogging. Inspect and maintain the filtration system as part of routine service.
More product details
- Air and electrical planning
- Published air demand is 250–1,000 L/min depending on setup. The supply table lists 110 V or 230 V, single-phase, 50/60 Hz, 10 A and 1.0 kW; match the ordered version and machine nameplate before sizing the circuit.
- Working capacity
- The manufacturer lists wheels up to 762 mm (30 inches). Confirm tyre condition, loading clearance and fixtures for the wheels you intend to process; the 698.5 mm table diameter is not the wheel-diameter limit.
- Time and consumables
- The manufacturer’s WM750 example is 2–3 minutes of preparation per wheel, with approximately 9–10 g of media consumption. Results depend on coating, damage, media and settings; they are not a guaranteed job cost or throughput.
M&H GROUP / WM710
Specify your request.
Share your wheel sizes, expected volume, available floor space and utilities. We will confirm the supplied equipment, installation, training and aftersales arrangements in your quotation.
Get advice from M&H Sales →Your selected article is included in the request. No payment or order is placed here.




